FOXBORO FBM01 8-Channel Isolated 0~20.4mA Analog Input Fieldbus Module I A Series Legacy 100 Series DCS

Manufacturer: FOXBORO (Schneider Electric Process Automation)

Part Number: FBM01 (Legacy 100 Series original mA analog input module, predecessor of Compact 200 FBM201, PN P0400DA)

Product Type: Legacy 100 Series current-type analog input FBM, channel galvanic isolation, non-native HART support, redundant fieldbus communication, simplex/master-tracker hot redundant rack compatible

Matching Platform: Foxboro I/A Series DCS 100 Series rack system, redundant Fieldbus, ZCP control processors, legacy TA termination assembly, dedicated 100-series interconnection cable, pre-2000 I/A hardware platform

Core Function: 8 fully galvanically isolated 0~20.4mA DC analog input channels; accepts 2-wire 4–20mA passive transmitters and self-powered current signal sources; high-precision Σ-Δ ADC conversion; software configurable integration filter & rate-of-change alarm threshold; per-channel open/short circuit continuous fault detection; 600VAC channel-to-ground isolation withstand; dual redundant fieldbus communication; configurable conversion scan time; front panel multi-color LED array for RUN/BUS/FAULT/individual channel status; maximum 14W power consumption; ISA G3 harsh industrial PCB; hot-swap replaceable on legacy 100-series baseplate

1. Product Overview

FBM01 is the original legacy 100-series 4–20mA analog input module for Foxboro I/A Series DCS, the generation predecessor of Compact 200 FBM201, widely deployed in early power, petrochemical and offshore DCS projects before Compact 200 launch. Equipped with 8 independent fully isolated current input channels, fixed signal range 0~20.4mA DC, designed exclusively for standard two-wire passive pressure, flow, level and temperature transmitters; no native HART signal decoding capability (only pure analog current collection, HART instruments require separate signal isolator for FBM01). Each channel adopts 600VAC withstand galvanic isolation to eliminate ground loop cross-talk interference caused by multi-point plant earthing. High-resolution sigma-delta conversion delivers ultra-high measurement accuracy ±0.05% FS; user-adjustable integration time suppresses 50/60Hz power frequency electromagnetic noise from inverters and large motors; built-in rate-of-change alarm logic triggers interlock protection when current deviates faster than set limits to prevent process drift escalation. Continuous per-channel self-diagnostics flag open sensor leads, shorted wiring and out-of-range current values, fault codes transmitted to DCS operator station alongside front panel LED status indicators for rapid on-site troubleshooting without portable test equipment. Supports master-tracker hot redundant pairing: two FBM01 units share one legacy TA termination base via redundant adapter, sampling process signals synchronously. If the primary module fails, the standby tracker takes over all measurement loops within milliseconds with zero current signal fluctuation, eliminating single-point failure risk for critical boiler, reactor and compressor monitoring loops. Dual redundant proprietary fieldbus links connect to upstream control processor; full-size legacy 100-series mechanical form factor, matched with dedicated old-spec interconnection wiring harness for cabinet marshalling. Compliant with ISA S71.04 Class G3 harsh industrial standard, resistant to dust, high humidity and mild chemical vapors; no factory conformal coating option for offshore salt-fog environments (replaced by FBM201 series for new offshore builds). This FBM01 legacy analog input module is critical spare I/O hardware for aging I/A Series 100-series DCS control cabinets, used for old plant system maintenance, obsolete channel hardware fault replacement and partial cabinet technical renovation.

Write a review

Your Name

Your Review

Rating

Continue